P0117 Engine Coolant Temperature Sensor 1 Circuit Low
What it means
The coolant temperature sensor is reporting an impossibly hot engine. That usually means a shorted wire or failed sensor, but make sure the engine isn't really overheating.
Can I keep driving?
This code can come from a real overheat, so take it seriously. If the gauge reads high, you see steam or smell coolant, pull over and shut it off. Check the coolant level when the engine is cold. If the temperature looks normal and it runs well, get it to a shop soon.
What to test before replacing parts
Confirm the engine isn't actually overheating, compare the sensor reading to actual temperature, and check the signal wire for a short to ground before replacing the sensor.
- Confirm the engine is not really overheating and coolant is full
- Unplug the sensor and see if the reading drops to a very cold value
- Inspect the wiring for pinched or melted spots
Signs you may notice
- Check engine light on
- Cooling fans running constantly
- Hard starting or rough running when cold
- Temperature gauge may read high
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed coolant temperature sensor
- CommonSignal wire shorted to ground
- PossibleEngine actually overheating
- PossibleDamaged connector
Typical repair once the cause is confirmed
Repair the shorted wiring or replace the coolant temperature sensor.
Common questions
What does P0117 mean?
The coolant temperature sensor is reporting an impossibly hot engine. That usually means a shorted wire or failed sensor, but make sure the engine isn't really overheating.
Can I drive with code P0117?
This code can come from a real overheat, so take it seriously. If the gauge reads high, you see steam or smell coolant, pull over and shut it off. Check the coolant level when the engine is cold. If the temperature looks normal and it runs well, get it to a shop soon.
What causes P0117?
Common possibilities to test include: failed coolant temperature sensor; signal wire shorted to ground; engine actually overheating; damaged connector. A shop should confirm the cause before replacing parts.