Home › Code lookup › P011A
Powertrain code · Cooling

P011A Engine Coolant Temperature Sensor 1/2 Correlation

How urgent? Book a check when convenient

What it means

Engines with two coolant temperature sensors expect them to read about the same. This code means the two readings disagree by too much.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the coolant level and bleed the system
  2. Compare both sensor readings on a cold engine after the car sits

Signs you may notice

  • Check engine light on
  • Temperature gauge may read oddly
  • Usually no change in drivability

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOne coolant temperature sensor reading wrong
  • CommonLow coolant or air trapped near one sensor
  • PossibleCorroded connector or high wiring resistance

Typical repair once the cause is confirmed

Replace the sensor that reads out of line, or fix the coolant level or wiring problem.

Known on these vehicles

Walk through it step by step: Temperature gauge goes up and down →

Common questions

What does P011A mean?

Engines with two coolant temperature sensors expect them to read about the same. This code means the two readings disagree by too much.

Can I drive with code P011A?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P011A?

Common possibilities to test include: one coolant temperature sensor reading wrong; low coolant or air trapped near one sensor; corroded connector or high wiring resistance. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.