P0123 Throttle/Pedal Position Sensor/Switch "A" Circuit High
What it means
Throttle position sensor A is sending a signal that is higher than normal, usually from a short in the wiring, a bad ground or a failed sensor. The car may limit power.
Can I keep driving?
Limit driving. Throttle sensor faults can cause sudden reduced power, surging, a high idle or stalling, which is dangerous in traffic or when merging. If the car won't accelerate properly, surges on its own or stalls, don't drive it in traffic; have it towed or move it only a short distance.
What to test before replacing parts
Check the throttle body and pedal sensor connectors, 5-volt reference and ground, and compare sensor readings as the throttle moves before replacing the throttle body or pedal.
- Inspect the throttle body connector and wiring
- Check the sensor ground and signal voltage at closed throttle
- Watch the live reading while slowly pressing the pedal
Signs you may notice
- Check engine light on
- Reduced power or limp mode
- High or surging idle
- Hesitation or poor shifting
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed throttle position sensor or throttle body
- CommonOpen sensor ground wire
- PossibleSignal wire shorted to voltage
- PossibleCorroded connector
Typical repair once the cause is confirmed
Repair the wiring or ground, or replace the throttle position sensor or throttle body.
Known on these vehicles
Common questions
What does P0123 mean?
Throttle position sensor A is sending a signal that is higher than normal, usually from a short in the wiring, a bad ground or a failed sensor. The car may limit power.
Can I drive with code P0123?
Limit driving. Throttle sensor faults can cause sudden reduced power, surging, a high idle or stalling, which is dangerous in traffic or when merging. If the car won't accelerate properly, surges on its own or stalls, don't drive it in traffic; have it towed or move it only a short distance.
What causes P0123?
Common possibilities to test include: failed throttle position sensor or throttle body; open sensor ground wire; signal wire shorted to voltage; corroded connector. A shop should confirm the cause before replacing parts.