Home › Code lookup › P0124
Powertrain code · Fuel and air

P0124 Throttle/Pedal Position Sensor/Switch "A" Circuit Intermittent

How urgent? Get it checked in the next few days

What it means

Throttle position sensor A's signal keeps dropping out or jumping, usually from a worn sensor or a loose connection.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Watch the live throttle reading while slowly pressing the pedal and look for spikes or drops
  2. Wiggle-test the connector and wiring

Signs you may notice

  • Check engine light on
  • Occasional stumble, surge or hesitation
  • Possible reduced power mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWorn throttle position sensor
  • CommonLoose or corroded connector
  • PossibleIntermittent wiring break

Typical repair once the cause is confirmed

Repair the connection, or replace the throttle position sensor or throttle body.

Walk through it step by step: Hesitation when accelerating →

Common questions

What does P0124 mean?

Throttle position sensor A's signal keeps dropping out or jumping, usually from a worn sensor or a loose connection.

Can I drive with code P0124?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0124?

Common possibilities to test include: worn throttle position sensor; loose or corroded connector; intermittent wiring break. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.