P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control
What it means
The engine is taking too long to warm up enough for the computer to start fine-tuning the fuel mixture. A thermostat stuck open is the usual cause.
Can I keep driving?
Usually drivable. The engine is running cooler than it should, so expect weak heat and slightly worse fuel economy. In cold weather a weak defroster can block your view, so get it fixed before winter. If the gauge ever reads high or you see steam, pull over and shut it off.
What to test before replacing parts
Check coolant level, compare the coolant sensor reading to actual engine temperature, watch how long warm-up takes, and confirm the fan isn't stuck on before replacing the thermostat.
- Check the coolant level
- Watch the coolant temperature as the engine warms; it should reach normal within about 10 to 15 minutes
- Check whether the cooling fan is running on a cold engine
Signs you may notice
- Check engine light on
- Temperature gauge slow to rise or stays low
- Heater slow to blow warm air
- Lower fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonThermostat stuck open or opening too early
- CommonFaulty coolant temperature sensor
- PossibleLow coolant level
- PossibleCooling fan running all the time
Typical repair once the cause is confirmed
Usually a new thermostat; replace the coolant temperature sensor if it reads wrong.
Known on these vehicles
Common questions
What does P0125 mean?
The engine is taking too long to warm up enough for the computer to start fine-tuning the fuel mixture. A thermostat stuck open is the usual cause.
Can I drive with code P0125?
Usually drivable. The engine is running cooler than it should, so expect weak heat and slightly worse fuel economy. In cold weather a weak defroster can block your view, so get it fixed before winter. If the gauge ever reads high or you see steam, pull over and shut it off.
What causes P0125?
Common possibilities to test include: thermostat stuck open or opening too early; faulty coolant temperature sensor; low coolant level; cooling fan running all the time. A shop should confirm the cause before replacing parts.