Home › Code lookup › P0127
Powertrain code · Fuel and air

P0127 Intake Air Temperature Too High

How urgent? Get it checked in the next few days

What it means

The air going into the engine is hotter than expected. This often shows up on turbocharged or supercharged engines when the intercooler isn't cooling the air well.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Compare the intake air reading to outside temperature on a cold engine
  2. On boosted engines, check the intercooler, its coolant level and pump

Signs you may notice

  • Check engine light on
  • Reduced power, especially when hot
  • Possible spark knock or pinging

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonIntercooler not cooling (failed pump, low coolant or blocked fins)
  • CommonFaulty intake air temperature sensor
  • PossibleWiring or connector fault
  • PossibleHot air being drawn in from a damaged intake duct

Typical repair once the cause is confirmed

Repair the intercooler system or air duct, or replace the intake air temperature sensor.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P0127 mean?

The air going into the engine is hotter than expected. This often shows up on turbocharged or supercharged engines when the intercooler isn't cooling the air well.

Can I drive with code P0127?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0127?

Common possibilities to test include: intercooler not cooling (failed pump, low coolant or blocked fins); faulty intake air temperature sensor; wiring or connector fault; hot air being drawn in from a damaged intake duct. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.