Home › Code lookup › P012A
Powertrain code · Fuel and air

P012A Turbocharger/Supercharger Inlet Pressure Sensor Circuit

How urgent? Get it checked in the next few days

What it means

On a turbocharged or supercharged engine, there's an electrical problem with a pressure sensor in the boosted intake air path. The computer uses it to control boost, so power may be limited.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring near the intercooler piping or throttle body
  2. Measure the sensor's 5-volt reference, ground and signal

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode
  • Weak acceleration

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged, oily or corroded sensor connector
  • CommonFailed pressure sensor
  • PossibleOpen or shorted wiring

Typical repair once the cause is confirmed

Repair the connector or wiring, or replace the pressure sensor.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P012A mean?

On a turbocharged or supercharged engine, there's an electrical problem with a pressure sensor in the boosted intake air path. The computer uses it to control boost, so power may be limited.

Can I drive with code P012A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P012A?

Common possibilities to test include: unplugged, oily or corroded sensor connector; failed pressure sensor; open or shorted wiring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.