Home › Code lookup › P012B
Powertrain code · Fuel and air

P012B Turbocharger/Supercharger Inlet Pressure Sensor Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

On a boosted engine, the intake pressure sensor's readings don't match what the computer expects. Often there's a boost leak, or the sensor is reading wrong.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect intercooler hoses and clamps for leaks or oil residue
  2. Compare the sensor reading with key on, engine off to the barometric pressure reading
  3. Smoke- or pressure-test the boost system

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode
  • Hesitation under boost

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBoost leak from a loose clamp or cracked intercooler hose
  • CommonFaulty pressure sensor
  • PossibleOil-soaked or corroded sensor connector
  • PossibleTurbocharger or wastegate problem

Typical repair once the cause is confirmed

Fix any boost leak first; replace the pressure sensor if readings stay wrong.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P012B mean?

On a boosted engine, the intake pressure sensor's readings don't match what the computer expects. Often there's a boost leak, or the sensor is reading wrong.

Can I drive with code P012B?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P012B?

Common possibilities to test include: boost leak from a loose clamp or cracked intercooler hose; faulty pressure sensor; oil-soaked or corroded sensor connector; turbocharger or wastegate problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.