Home › Code lookup › P012C
Powertrain code · Fuel and air

P012C Turbocharger/Supercharger Inlet Pressure Sensor Circuit Low

How urgent? Get it checked in the next few days

What it means

On a boosted engine, the intake pressure sensor's signal is lower than its normal range, usually from a wiring or connector problem or a failed sensor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring
  2. Measure the sensor's 5-volt reference, ground and signal

Signs you may notice

  • Check engine light on
  • Reduced power or limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged or corroded connector
  • CommonFailed pressure sensor
  • PossibleSignal wire open or shorted to ground, or lost 5-volt reference

Typical repair once the cause is confirmed

Repair the wiring or connector, or replace the pressure sensor.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P012C mean?

On a boosted engine, the intake pressure sensor's signal is lower than its normal range, usually from a wiring or connector problem or a failed sensor.

Can I drive with code P012C?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P012C?

Common possibilities to test include: unplugged or corroded connector; failed pressure sensor; signal wire open or shorted to ground, or lost 5-volt reference. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.