P012D Turbocharger/Supercharger Inlet Pressure Sensor Circuit High
What it means
On a boosted engine, the intake pressure sensor's signal is higher than its normal range, usually from a short in the wiring, a bad ground or a failed sensor.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the sensor wiring for damage
- Check the sensor ground and signal voltage with the engine off
Signs you may notice
- Check engine light on
- Reduced power or limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed pressure sensor
- CommonOpen sensor ground
- PossibleSignal wire shorted to voltage
Typical repair once the cause is confirmed
Repair the wiring or ground, or replace the pressure sensor.
Common questions
What does P012D mean?
On a boosted engine, the intake pressure sensor's signal is higher than its normal range, usually from a short in the wiring, a bad ground or a failed sensor.
Can I drive with code P012D?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P012D?
Common possibilities to test include: failed pressure sensor; open sensor ground; signal wire shorted to voltage. A shop should confirm the cause before replacing parts.