Home › Code lookup › P012E
Powertrain code · Fuel and air

P012E Turbocharger/Supercharger Inlet Pressure Sensor Circuit Intermittent/Erratic

How urgent? Get it checked in the next few days

What it means

On a boosted engine, the intake pressure sensor's signal keeps dropping out or jumping, usually from a loose connection or a failing sensor.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle-test the connector and harness while watching the live reading
  2. Clean any oil out of the connector

Signs you may notice

  • Check engine light on
  • Occasional loss of power or limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose, oily or corroded connector
  • CommonIntermittent wiring break
  • PossibleFailing pressure sensor

Typical repair once the cause is confirmed

Repair the connection or wiring; replace the sensor if the signal still jumps.

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P012E mean?

On a boosted engine, the intake pressure sensor's signal keeps dropping out or jumping, usually from a loose connection or a failing sensor.

Can I drive with code P012E?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P012E?

Common possibilities to test include: loose, oily or corroded connector; intermittent wiring break; failing pressure sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.