P0130 O2 Sensor Circuit (Bank 1 Sensor 1)
What it means
There's a problem with the front oxygen sensor on bank 1, the one before the catalytic converter. It tells the computer whether the engine is running rich or lean.
Can I keep driving?
Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.
What to test before replacing parts
Check the sensor wiring and connector near the exhaust, look for exhaust leaks ahead of the sensor, and watch the sensor signal on a scan tool before replacing it.
- Inspect the sensor wiring where it runs near hot exhaust parts
- Look and listen for exhaust leaks ahead of the sensor
- Watch the live sensor reading; a healthy one switches quickly between rich and lean
Signs you may notice
- Check engine light on
- Lower fuel economy
- Possible rough idle or hesitation
- May fail an emissions test
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed upstream oxygen sensor
- CommonDamaged or burned wiring near the exhaust
- PossibleExhaust leak near the sensor
- PossibleCorroded or loose connector
Typical repair once the cause is confirmed
Usually a new upstream oxygen sensor, or a wiring or exhaust leak repair.
Known on these vehicles
Common questions
What does P0130 mean?
There's a problem with the front oxygen sensor on bank 1, the one before the catalytic converter. It tells the computer whether the engine is running rich or lean.
Can I drive with code P0130?
Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.
What causes P0130?
Common possibilities to test include: failed upstream oxygen sensor; damaged or burned wiring near the exhaust; exhaust leak near the sensor; corroded or loose connector. A shop should confirm the cause before replacing parts.