Home › Code lookup › P0135
Powertrain code · Emissions

P0135 O2 Sensor Heater Circuit (Bank 1 Sensor 1)

How urgent? Book a check when convenient

What it means

The front oxygen sensor on bank 1 has a built-in heater so it starts working quickly. This code means that heater or its wiring has a problem.

Can I keep driving?

Usually you can keep driving normally and schedule a repair; the heater only helps the oxygen sensor warm up quickly. Get it checked sooner if the engine starts running rough, other codes appear, or you smell fuel. The car may not pass an emissions or inspection test until it's fixed.

What to test before replacing parts

Check the O2 heater fuse first, then measure heater resistance and check power and ground at the connector. Inspect the wiring near the exhaust for melting before replacing the sensor.

  1. Check the fuse that powers the oxygen sensor heaters
  2. Measure the heater resistance at the sensor connector
  3. Inspect the sensor wiring for melted or chafed spots

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • Slightly worse fuel economy after cold starts
  • May fail an emissions test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonBurned-out heater inside the oxygen sensor
  • CommonBlown oxygen sensor heater fuse
  • PossibleDamaged wiring or connector near the exhaust
  • PossibleFaulty heater control in the engine computer

Typical repair once the cause is confirmed

Usually a new upstream oxygen sensor; check the fuse and wiring first.

Repair costInsufficient verified pricing for this vehicle and repair
Replace upstream oxygen sensor (bank 1). Prepare an itemized shop request.

Where it shows up

  • Very common at high mileage as the heater element inside the sensor burns out
Walk through it step by step: Check engine light on →

Common questions

What does P0135 mean?

The front oxygen sensor on bank 1 has a built-in heater so it starts working quickly. This code means that heater or its wiring has a problem.

Can I drive with code P0135?

Usually you can keep driving normally and schedule a repair; the heater only helps the oxygen sensor warm up quickly. Get it checked sooner if the engine starts running rough, other codes appear, or you smell fuel. The car may not pass an emissions or inspection test until it's fixed.

What causes P0135?

Common possibilities to test include: burned-out heater inside the oxygen sensor; blown oxygen sensor heater fuse; damaged wiring or connector near the exhaust; faulty heater control in the engine computer. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.