Home › Code lookup › P0140
Powertrain code · Emissions

P0140 O2 Sensor Circuit No Activity Detected (Bank 1 Sensor 2)

How urgent? Book a check when convenient

What it means

The rear oxygen sensor on bank 1 isn't sending any changing signal. It may be dead, unplugged, or its heater may have failed.

Can I keep driving?

Usually you can keep driving normally and schedule a repair; this rear sensor mainly monitors the catalytic converter. The car may fail an emissions test. If the engine runs rough, the check engine light flashes, or you smell rotten eggs or fuel, get it checked sooner.

What to test before replacing parts

Check the heater fuse, wiring and connector for opens, and confirm the signal stays flat with a warm engine before replacing the sensor.

  1. Check that the sensor connector is plugged in and not corroded
  2. Check for heater circuit codes and the heater fuse
  3. Watch the live reading on a warm engine; a flat reading near 0.45 volts means no activity

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed downstream oxygen sensor
  • CommonOpen circuit in the wiring under the car
  • PossibleSensor heater not working
  • PossibleUnplugged or corroded connector

Typical repair once the cause is confirmed

Usually a new downstream oxygen sensor, or a wiring repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace downstream oxygen sensor (bank 1). Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0140 mean?

The rear oxygen sensor on bank 1 isn't sending any changing signal. It may be dead, unplugged, or its heater may have failed.

Can I drive with code P0140?

Usually you can keep driving normally and schedule a repair; this rear sensor mainly monitors the catalytic converter. The car may fail an emissions test. If the engine runs rough, the check engine light flashes, or you smell rotten eggs or fuel, get it checked sooner.

What causes P0140?

Common possibilities to test include: failed downstream oxygen sensor; open circuit in the wiring under the car; sensor heater not working; unplugged or corroded connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.