Home › Code lookup › P0150
Powertrain code · Emissions

P0150 O2 Sensor Circuit (Bank 2 Sensor 1)

How urgent? Book a check when convenient

What it means

There's a problem with the front oxygen sensor on bank 2 (the side of a V6 or V8 without cylinder 1). It sits before the catalytic converter and helps set the fuel mixture.

Can I keep driving?

Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.

What to test before replacing parts

Check the sensor wiring and connector near the exhaust, look for exhaust leaks ahead of the sensor, and watch the sensor signal on a scan tool before replacing it.

  1. Inspect the sensor wiring where it runs near hot exhaust parts
  2. Check for exhaust manifold leaks on bank 2
  3. Watch the live sensor reading for normal rich-lean switching

Signs you may notice

  • Check engine light on
  • Lower fuel economy
  • Possible rough idle or hesitation
  • May fail an emissions test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed upstream oxygen sensor
  • CommonDamaged or burned wiring near the exhaust
  • PossibleExhaust leak near the sensor
  • PossibleCorroded or loose connector

Typical repair once the cause is confirmed

Usually a new upstream oxygen sensor, or a wiring or exhaust leak repair.

Repair costInsufficient verified pricing for this vehicle and repair
Replace upstream oxygen sensor (bank 2). Prepare an itemized shop request.
Walk through it step by step: Gas mileage suddenly worse →

Common questions

What does P0150 mean?

There's a problem with the front oxygen sensor on bank 2 (the side of a V6 or V8 without cylinder 1). It sits before the catalytic converter and helps set the fuel mixture.

Can I drive with code P0150?

Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.

What causes P0150?

Common possibilities to test include: failed upstream oxygen sensor; damaged or burned wiring near the exhaust; exhaust leak near the sensor; corroded or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.