Home › Code lookup › P0153
Powertrain code · Emissions

P0153 O2 Sensor Circuit Slow Response (Bank 2 Sensor 1)

How urgent? Book a check when convenient

What it means

The front oxygen sensor on bank 2 is reacting too slowly to changes in the exhaust, which usually means it's worn out.

Can I keep driving?

Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.

What to test before replacing parts

Check for exhaust and vacuum leaks and review fuel trims, then confirm the sensor's switching speed on a scan tool or scope before replacing it.

  1. Watch the live sensor reading at a steady 2,500 rpm; it should switch rich and lean quickly
  2. Check for exhaust leaks ahead of the sensor
  3. Check for oil burning or coolant loss

Signs you may notice

  • Check engine light on
  • Lower fuel economy
  • Usually no obvious change in driving

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonAged or worn upstream oxygen sensor
  • CommonSensor contaminated by oil, coolant or additives
  • PossibleExhaust leak near the sensor
  • PossibleVacuum leak or other fuel mixture problem

Typical repair once the cause is confirmed

Usually a new upstream oxygen sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace upstream oxygen sensor (bank 2). Prepare an itemized shop request.
Walk through it step by step: Gas mileage suddenly worse →

Common questions

What does P0153 mean?

The front oxygen sensor on bank 2 is reacting too slowly to changes in the exhaust, which usually means it's worn out.

Can I drive with code P0153?

Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.

What causes P0153?

Common possibilities to test include: aged or worn upstream oxygen sensor; sensor contaminated by oil, coolant or additives; exhaust leak near the sensor; vacuum leak or other fuel mixture problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.