Home › Code lookup › P0157
Powertrain code · Emissions

P0157 O2 Sensor Circuit Low Voltage (Bank 2 Sensor 2)

How urgent? Book a check when convenient

What it means

The rear oxygen sensor on bank 2 is stuck reading low (lean). An exhaust leak letting in outside air or a failed sensor is the usual cause.

Can I keep driving?

Usually you can keep driving normally and schedule a repair; this rear sensor mainly monitors the catalytic converter. The car may fail an emissions test. If the engine runs rough, the check engine light flashes, or you smell rotten eggs or fuel, get it checked sooner.

What to test before replacing parts

Check for exhaust leaks near the sensor and shorts to ground, and review fuel trims for a real lean condition before replacing the sensor.

  1. Look and listen for exhaust leaks around the converter and sensor
  2. Inspect the wiring under the car
  3. Check fuel trims for a real lean condition

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions test

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed downstream oxygen sensor
  • CommonExhaust leak near the sensor
  • PossibleSignal wire shorted to ground
  • PossibleReal lean condition

Typical repair once the cause is confirmed

Fix any exhaust leak; otherwise replace the downstream oxygen sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace downstream oxygen sensor (bank 2). Prepare an itemized shop request.
Walk through it step by step: Check engine light on →

Common questions

What does P0157 mean?

The rear oxygen sensor on bank 2 is stuck reading low (lean). An exhaust leak letting in outside air or a failed sensor is the usual cause.

Can I drive with code P0157?

Usually you can keep driving normally and schedule a repair; this rear sensor mainly monitors the catalytic converter. The car may fail an emissions test. If the engine runs rough, the check engine light flashes, or you smell rotten eggs or fuel, get it checked sooner.

What causes P0157?

Common possibilities to test include: failed downstream oxygen sensor; exhaust leak near the sensor; signal wire shorted to ground; real lean condition. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.