Home › Code lookup › P018A
Powertrain code · Fuel and air

P018A Fuel Pressure Sensor "B" Circuit

How urgent? Get it checked in the next few days

What it means

There's an electrical problem with fuel pressure sensor B, a second fuel pressure sensor used on some engines (often on the low-pressure supply side).

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the sensor connector and wiring
  2. Check the sensor's 5-volt reference, ground and signal

Signs you may notice

  • Check engine light on
  • Possible hard starting or loss of power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonUnplugged or corroded sensor connector
  • CommonFailed fuel pressure sensor B
  • PossibleOpen or shorted wiring

Typical repair once the cause is confirmed

Repair the wiring or connector, or replace fuel pressure sensor B.

Walk through it step by step: Car has no power when accelerating →

Common questions

What does P018A mean?

There's an electrical problem with fuel pressure sensor B, a second fuel pressure sensor used on some engines (often on the low-pressure supply side).

Can I drive with code P018A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P018A?

Common possibilities to test include: unplugged or corroded sensor connector; failed fuel pressure sensor b; open or shorted wiring. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.