P0190 Fuel Rail Pressure Sensor "A" Circuit
What it means
There's an electrical problem with the sensor that measures fuel pressure in the fuel rail. Diesels and direct-injection gas engines rely on it heavily, so starting and power can suffer.
Can I keep driving?
Limit driving. This fault can cause sudden power loss, limp mode or stalling, which is risky in traffic or on the highway. If the engine stalls, struggles to restart, or you smell fuel, don't keep driving. If it runs normally, keep trips short and get it checked soon.
What to test before replacing parts
Check the sensor connector, 5-volt reference, ground and signal wiring, and compare the sensor reading to actual fuel pressure on a gauge before replacing the sensor or pump.
- Inspect the sensor connector and wiring on the fuel rail
- Check the sensor's 5-volt reference, ground and signal
- Look for other codes sharing the same 5-volt reference
Signs you may notice
- Check engine light on
- Hard starting or no start
- Loss of power or limp mode
- Stalling
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed fuel rail pressure sensor
- CommonUnplugged or corroded connector
- PossibleOpen or shorted wiring
- PossibleLost 5-volt reference from the engine computer
Typical repair once the cause is confirmed
Repair the wiring or connector, or replace the fuel rail pressure sensor.
Common questions
What does P0190 mean?
There's an electrical problem with the sensor that measures fuel pressure in the fuel rail. Diesels and direct-injection gas engines rely on it heavily, so starting and power can suffer.
Can I drive with code P0190?
Limit driving. This fault can cause sudden power loss, limp mode or stalling, which is risky in traffic or on the highway. If the engine stalls, struggles to restart, or you smell fuel, don't keep driving. If it runs normally, keep trips short and get it checked soon.
What causes P0190?
Common possibilities to test include: failed fuel rail pressure sensor; unplugged or corroded connector; open or shorted wiring; lost 5-volt reference from the engine computer. A shop should confirm the cause before replacing parts.