Home › Code lookup › P0192
Powertrain code · Fuel and air

P0192 Fuel Rail Pressure Sensor "A" Circuit Low

How urgent? Get it checked in the next few days

What it means

The fuel rail pressure sensor's signal is lower than its normal range, usually from a wiring fault or failed sensor.

Can I keep driving?

Limit driving. This fault can cause sudden power loss, limp mode or stalling, which is risky in traffic or on the highway. If the engine stalls, struggles to restart, or you smell fuel, don't keep driving. If it runs normally, keep trips short and get it checked soon.

What to test before replacing parts

Check the sensor connector, 5-volt reference, ground and signal wiring, and compare the sensor reading to actual fuel pressure on a gauge before replacing the sensor or pump.

  1. Inspect the sensor connector and wiring
  2. Check the sensor's 5-volt reference, ground and signal
  3. Look for other codes sharing the same 5-volt reference

Signs you may notice

  • Check engine light on
  • Hard starting or no start
  • Loss of power
  • Stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed fuel rail pressure sensor
  • CommonSignal wire open or shorted to ground
  • PossibleLost 5-volt reference
  • PossibleCorroded connector

Typical repair once the cause is confirmed

Repair the wiring or replace the fuel rail pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace fuel rail pressure sensor. Prepare an itemized shop request.
Walk through it step by step: Car won't start →

Common questions

What does P0192 mean?

The fuel rail pressure sensor's signal is lower than its normal range, usually from a wiring fault or failed sensor.

Can I drive with code P0192?

Limit driving. This fault can cause sudden power loss, limp mode or stalling, which is risky in traffic or on the highway. If the engine stalls, struggles to restart, or you smell fuel, don't keep driving. If it runs normally, keep trips short and get it checked soon.

What causes P0192?

Common possibilities to test include: failed fuel rail pressure sensor; signal wire open or shorted to ground; lost 5-volt reference; corroded connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.