P0193 Fuel Rail Pressure Sensor "A" Circuit High
What it means
The fuel rail pressure sensor's signal is higher than its normal range, usually from a short in the wiring, an open ground or a failed sensor.
Can I keep driving?
Limit driving. This fault can cause sudden power loss, limp mode or stalling, which is risky in traffic or on the highway. If the engine stalls, struggles to restart, or you smell fuel, don't keep driving. If it runs normally, keep trips short and get it checked soon.
What to test before replacing parts
Check the sensor connector, 5-volt reference, ground and signal wiring, and compare the sensor reading to actual fuel pressure on a gauge before replacing the sensor or pump.
- Inspect the sensor wiring for damage
- Check the sensor ground and signal with the engine off
- Compare the reading with key on, engine off to the expected value
Signs you may notice
- Check engine light on
- Hard starting or no start
- Loss of power or limp mode
- Stalling
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed fuel rail pressure sensor
- CommonOpen sensor ground wire
- PossibleSignal wire shorted to voltage
- PossibleEngine computer fault
Typical repair once the cause is confirmed
Repair the wiring or ground, or replace the fuel rail pressure sensor.
Common questions
What does P0193 mean?
The fuel rail pressure sensor's signal is higher than its normal range, usually from a short in the wiring, an open ground or a failed sensor.
Can I drive with code P0193?
Limit driving. This fault can cause sudden power loss, limp mode or stalling, which is risky in traffic or on the highway. If the engine stalls, struggles to restart, or you smell fuel, don't keep driving. If it runs normally, keep trips short and get it checked soon.
What causes P0193?
Common possibilities to test include: failed fuel rail pressure sensor; open sensor ground wire; signal wire shorted to voltage; engine computer fault. A shop should confirm the cause before replacing parts.