Home › Code lookup › P0829
Powertrain code · Transmission

P0829 5-6 Shift

How urgent? Get it checked in the next few days

What it means

The transmission computer found a problem with the shift between 5th and 6th gear: it took too long, did not happen, or did not feel right.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fluid level and condition
  2. Check for software updates or service bulletins
  3. Watch the 5-6 shift on a scan tool during a road test

Signs you may notice

  • Check engine light on
  • No 6th gear or a flare during the 5-6 shift
  • Higher engine speed on the highway

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow or worn-out transmission fluid
  • CommonShift solenoid or valve body problem
  • PossibleWorn clutch pack inside the transmission
  • PossibleControl module software needs an update

Typical repair once the cause is confirmed

Correct the fluid and check for updates first; solenoid or internal repair may be needed.

Walk through it step by step: Transmission slipping →

Common questions

What does P0829 mean?

The transmission computer found a problem with the shift between 5th and 6th gear: it took too long, did not happen, or did not feel right.

Can I drive with code P0829?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0829?

Common possibilities to test include: low or worn-out transmission fluid; shift solenoid or valve body problem; worn clutch pack inside the transmission; control module software needs an update. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.