Home › Code lookup › P0882
Powertrain code · Electrical

P0882 TCM Power Input Signal Low

How urgent? Get it checked in the next few days

What it means

The transmission computer is seeing lower voltage than it needs on its power feed. A weak battery or bad connection is the usual reason.

Can I keep driving?

Often drivable with care to a shop soon, but low voltage to the transmission computer can leave it in one gear and may mean the battery or charging system is failing. If other warnings appear, it cranks slowly or lights dim, it could stall or not restart, so go straight to a shop.

What to test before replacing parts

Test the battery and charging system, then check the transmission computer's power feed, fuses, relay and ground connections for voltage drop before replacing the module.

  1. Test the battery and charging system
  2. Clean and tighten battery terminals and main grounds
  3. Check the TCM fuse and relay and voltage at the module

Signs you may notice

  • Check engine light on
  • Transmission stuck in one gear (limp mode)
  • Harsh shifts or no upshifts
  • Slow cranking or other low-voltage warnings

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWeak or failing battery
  • CommonLoose or corroded battery terminals or grounds
  • CommonBlown fuse or bad relay in the TCM power feed
  • PossibleCharging system not keeping the battery up
  • PossibleDamaged wiring or a faulty transmission computer

Typical repair once the cause is confirmed

Usually fixed by replacing a weak battery or cleaning bad connections; clear the code and check that it stays off.

Repair costInsufficient verified pricing for this vehicle and repair

Where it shows up

  • Often set on Chrysler and Dodge vehicles after a weak battery, dead battery or jump start

Known on these vehicles

Walk through it step by step: Transmission warning light on →

Common questions

What does P0882 mean?

The transmission computer is seeing lower voltage than it needs on its power feed. A weak battery or bad connection is the usual reason.

Can I drive with code P0882?

Often drivable with care to a shop soon, but low voltage to the transmission computer can leave it in one gear and may mean the battery or charging system is failing. If other warnings appear, it cranks slowly or lights dim, it could stall or not restart, so go straight to a shop.

What causes P0882?

Common possibilities to test include: weak or failing battery; loose or corroded battery terminals or grounds; blown fuse or bad relay in the tcm power feed; charging system not keeping the battery up. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.