P0111 Intake Air Temperature Sensor 1 Circuit Range/Performance (Bank 1)
What it means
The intake air temperature reading doesn't make sense, such as not changing as the engine warms or not matching other temperature sensors after the car sits.
Can I keep driving?
Usually you can keep driving and schedule a repair. The car may start harder in cold weather or use a bit more fuel. If it starts running rough, hesitating or stalling, or other codes show up, get it checked sooner.
What to test before replacing parts
Compare the intake air temperature reading to outside air on a cold engine, confirm the sensor is mounted in the air stream, and check connector and wiring resistance.
- After the car sits overnight, compare the intake air and coolant temperature readings; they should be close
- Inspect the connector for corrosion
- Make sure the sensor is seated in the intake properly
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- Possible slight drop in fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty intake air temperature sensor
- CommonCorroded or loose connector
- PossibleSensor mounted wrong or out of the air stream
- PossibleHigh resistance in the wiring
Typical repair once the cause is confirmed
Usually a new intake air temperature sensor, or a MAF sensor where the two are combined.
Known on these vehicles
Common questions
What does P0111 mean?
The intake air temperature reading doesn't make sense, such as not changing as the engine warms or not matching other temperature sensors after the car sits.
Can I drive with code P0111?
Usually you can keep driving and schedule a repair. The car may start harder in cold weather or use a bit more fuel. If it starts running rough, hesitating or stalling, or other codes show up, get it checked sooner.
What causes P0111?
Common possibilities to test include: faulty intake air temperature sensor; corroded or loose connector; sensor mounted wrong or out of the air stream; high resistance in the wiring. A shop should confirm the cause before replacing parts.