P0131 O2 Sensor Circuit Low Voltage (Bank 1 Sensor 1)
What it means
The front oxygen sensor on bank 1 is stuck reading low, which looks like a very lean (too much air) mixture. It can be a real lean condition or a bad sensor or wire.
Can I keep driving?
Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.
What to test before replacing parts
Check for exhaust and vacuum leaks, review fuel trims to see if the engine is really lean, and check the signal wire for a short to ground before replacing the sensor.
- Check for exhaust leaks at the manifold and front pipe
- Look at fuel trims; high positive trims point to a real lean condition
- Inspect the sensor wiring for melted or rubbed spots
Signs you may notice
- Check engine light on
- Lower fuel economy
- Possible hesitation or rough idle
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed upstream oxygen sensor
- CommonExhaust leak ahead of the sensor pulling in outside air
- PossibleSignal wire shorted to ground
- PossibleReal lean condition from a vacuum leak or low fuel pressure
Typical repair once the cause is confirmed
Fix exhaust or vacuum leaks first; otherwise replace the upstream oxygen sensor.
Known on these vehicles
Common questions
What does P0131 mean?
The front oxygen sensor on bank 1 is stuck reading low, which looks like a very lean (too much air) mixture. It can be a real lean condition or a bad sensor or wire.
Can I drive with code P0131?
Usually you can keep driving for now, but get it checked within a week or two; a poor fuel mixture can harm the catalytic converter over time. If the check engine light flashes, the engine runs rough, or you smell fuel or rotten eggs, get it checked right away.
What causes P0131?
Common possibilities to test include: failed upstream oxygen sensor; exhaust leak ahead of the sensor pulling in outside air; signal wire shorted to ground; real lean condition from a vacuum leak or low fuel pressure. A shop should confirm the cause before replacing parts.