Home › Warning lights › Service due / maintenance light
Amber/yellow: check soon

Service due / maintenance light

Also called: Wrench light, Maint reqd, Oil life

How urgent? Check it when you can

What it means

A mileage or time reminder that routine service is due. On Ford and Lincoln the same wrench symbol means a powertrain fault instead, which is not a reminder and will not reset.

A small amber or yellow wrench in the instrument cluster, or a text message instead of a symbol. Toyota shows the words MAINT REQD, GM usually says CHANGE OIL SOON or SERVICE SOON, Honda shows a wrench plus an oil life reading, and BMW and Mercedes show a Service counter. On most Fords the same wrench is a powertrain warning, not a service reminder.

Can I keep driving?

Yes. Book the service soon. If it's a Ford wrench light with reduced power, get it checked sooner.

If it's flashing or blinking: On many Toyotas the MAINT REQD light flashes for a few seconds each time you start the car when the service is nearly due, then stays on steadily once it is due. A flashing wrench on other makes is not a standard signal, so read the message on the screen.

What to do now

  1. Check the maintenance message or oil life percentage.
  2. Get the service done, then have the reminder reset.

Common causes

  • Oil and filter change interval reached
  • Reminder not reset after the last service
  • A larger scheduled service due at this mileage
  • Electronic throttle body fault (Ford wrench light)
  • Accelerator pedal position sensor fault (Ford wrench light)

Checks you can do yourself

Safe, no tools in most cases

Do these with the car parked and the engine off and cool. If anything looks or smells hot, wait.

1
Read the message or oil life display

With the car parked and the engine off, turn the ignition on and look through the cluster menu with the arrow or trip buttons on the steering wheel or stalk. Most cars will tell you exactly what is due, such as oil and filter, or how much oil life is left. Write down what it says before you call a shop.

3 minutes · None
2
Check the engine oil level

Park on level ground with the engine off and cool. Pull the dipstick out, wipe it with a rag, push it fully back in, then pull it out again and look where the oil ends. It should sit between the two marks. If your car has no dipstick, use the oil level reading in the dash menu instead.

5 minutes · A rag or paper towel
3
Look for the last oil change sticker

Check the top corner of the windshield, the door frame or the oil cap area for a sticker from the last shop. Compare the mileage on it with the mileage on your dash. That tells you whether this really is an oil change coming due or a reminder nobody reset last time.

2 minutes · None
4
Look up the service due at this mileage

Open the owner's manual to the maintenance schedule and find the mileage closest to yours. It lists what is actually due, which may be more than oil, such as filters, spark plugs or a transmission fluid change. Knowing this stops a shop from selling you work your car does not need yet.

10 minutes · Owner's manual
5
On a Ford, notice how the car drives

If the wrench came on and the car feels slow, will not rev past a low point or the pedal feels dead, that is a powertrain fault and not a service reminder. Drive gently straight to a shop or home. Note whether it happens when cold, when warm or only sometimes, because that detail saves diagnosis time.

5 minutes · None

Step-by-step repair walkthroughs for the fixes below are on the way.

What not to do

  • Don't assume it means the engine is low on oil or about to fail; that is the red oil pressure light, not this one.
  • Don't reset the reminder and carry on without actually doing the service.
  • Don't ignore it for months, because oil that is long past due wears the engine quietly.
  • Don't keep driving hard on a Ford wrench light with reduced power; get it looked at.

What it usually turns out to be

Most likely first. Prices are typical US parts-and-labor totals for that repair, not a quote for your vehicle.

Oil and filter change interval reachedPrice not verified

How you can tell The message mentions oil, or the oil life counter has run down to nothing, and your mileage is close to the interval in the manual. It stores no trouble code, because nothing is broken. This is by far the most common reason the wrench or maintenance message appears.

The repair An oil and filter change using the grade of oil your manual calls for, then the reminder is reset.

Reminder never reset after the last servicePrice not verified

How you can tell You had the oil changed recently, the sticker mileage is close to today's mileage, and the oil on the dipstick still looks clean and honey coloured. The counter simply kept counting because the last shop skipped the reset step.

The repair A shop or you resets the maintenance counter. Many shops do it at no charge if they did the oil change.

A larger scheduled service is duePrice not verified

How you can tell The message names something other than oil, such as a filter, spark plugs, brake fluid or a transmission service, or your mileage has hit one of the bigger milestones in the manual. Common on cars at the thirty, sixty and ninety thousand mile marks.

The repair The shop carries out the items the manufacturer lists for that mileage, then resets the reminder.

Electronic throttle body fault (Ford wrench light)Price not verified

How you can tell The wrench comes on by itself on a Ford, the car goes into a low power mode, and the engine may idle rough or stall. A shop usually finds a throttle or pedal related code stored, often in the P2100s or P2111 and P2135. Switching the car off and on may clear it for a day or two before it returns.

The repair The throttle body is cleaned or replaced and the throttle position is relearned with a scan tool.

Accelerator pedal position sensor fault (Ford wrench light)Price not verified

How you can tell Same wrench and low power mode, but the fault follows the pedal rather than the engine, so the car may hesitate when you press down and feel normal at steady speed. The stored codes point at the pedal sensor instead of the throttle body.

The repair The pedal assembly with its built in sensor is replaced and the new one is relearned.

What a shop will do

A shop plugs in a scan tool first, because that tells them in a minute whether this is a plain maintenance counter or a real stored fault. If it is just the counter, they read what service is due, check your oil and service history, and the whole thing takes a quarter of an hour. If there are stored codes, as with a Ford wrench light and reduced power, they test the throttle and pedal signals, which takes about an hour.

How to reset this light

Do the service first, then reset the counter. With the doors shut and the engine off, turn the ignition to On without starting. Then use whichever of these your car has: hold the trip or odometer reset button until the display shows zeros (Toyota), hold the Select or Reset stem on the cluster until the wrench or oil icon blinks and the oil life goes back to full (Honda), or go through the dash menu to Settings, then Vehicle, then Oil Life Reset (Ford and many newer cars). Turn the ignition off, then start the engine and check the light is gone. Repeat the whole sequence if it is still on.

The exact steps change by make, model and year, so the owner's manual is the one that counts. Some older GM, Jeep and Ram models use the accelerator pedal instead, and some European cars need a scan tool.

Step by step

Pick your make for the button sequence

Exact steps for every single year and model are still being added. If your make isn't here yet, your owner's manual has the sequence.

Trouble codes often stored with this light

Common questions

What does the service due / maintenance light mean?

A mileage or time reminder that routine service is due. On Ford and Lincoln the same wrench symbol means a powertrain fault instead, which is not a reminder and will not reset.

Can I drive with the service due / maintenance light on?

Yes. Book the service soon. If it's a Ford wrench light with reduced power, get it checked sooner.

Does the service light mean my car is low on oil?

Usually no. On most cars it is a counter that runs on miles and time, so it comes on whether the oil is full or not. The light that genuinely means stop now is the red oil can, which is about oil pressure. Still check your oil level while you are at it, because a car due for service is often a little low too.

How long can I drive with the service light on?

You can drive normally and book the work in the next week or two. It is a reminder, not a breakdown warning. The exception is a Ford style wrench that came on with reduced power, because that is a fault and the car should be looked at straight away.

Will a service light fail an inspection or emissions test?

A maintenance or oil change reminder is not the check engine light, and emissions testing looks at the check engine light and the onboard monitors, not at a service counter. Some state safety inspections still note warning lamps, so if yours is due for inspection, get the service done and the reminder reset first.

Does the service light reset itself after an oil change?

No. Someone has to reset the counter, either the shop or you, using the button or menu sequence for your car. If the light is still on a day after an oil change, the shop most likely forgot that step, and a quick call usually sorts it.

Why is a wrench light on my Ford different?

Ford uses the wrench for powertrain problems rather than for scheduled servicing, and it often arrives with a loss of power so the car will barely accelerate. A throttle body or pedal sensor is the usual culprit. It cannot be reset with a button sequence, because it comes back until the fault is repaired.

Sources: NAPA Know How · Tires Plus · YourMechanic · CarComplaints

Not your light? These get mixed up with it

Symbols vary a little between makes. Your owner's manual shows the exact lights for your vehicle. This is a general guide, not a diagnosis.